1999 Front Brake Rotors
#1
1999 Front Brake Rotors
Ok I'm an Idiot! I did not check to make sure I had the right Rotors and I installed a set of front rotors that were not anti lock application. I found out on the test drive when the ABS light came on. I looked over the old rotor and found that they had a "ribbed" disk attached to the rear or the Hub, I was able to remove this. I assume this is what the sensor rides close to to work correctly.
I was wondering if that was the only difference between them and the new ones I installed. If so , can I just put these disks on the new rotors ? Also what would be the problem of leaving the new rotors on as is, the brakes work fine, I mean the truck stops fine and I feel no vibration, put the ABS light does remain on.
Thanks for any assistance, my first time to inquire on this site.
I was wondering if that was the only difference between them and the new ones I installed. If so , can I just put these disks on the new rotors ? Also what would be the problem of leaving the new rotors on as is, the brakes work fine, I mean the truck stops fine and I feel no vibration, put the ABS light does remain on.
Thanks for any assistance, my first time to inquire on this site.
Thread
Thread Starter
Forum
Replies
Last Post
Bigandrw
2004 - 2008 Ford F150
11
01-28-2018 07:39 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)