Going to be looking at 2006 F150 SCrew 4.6L
#1
Going to be looking at 2006 F150 SCrew 4.6L
Hey, new to this forum but not Fords. Have had a 99 F250 V10 w/ 3.73 and 01 F250 V8 w/ 4.10. Had them when my daughter got into horses which is a whole other story. Anyways, going to be looking at a 2006 SCrew 4.6L with 86K miles on it. I've got the VIN # and am going to call one of the local Ford service dept to see what they can tell me about the specifics. According to Carfax it's a 3 owner rig - I prefer 1 -2 owners but am willing to have a look. Any feedback would be appreciated.
BTW, they're asking $13,900 for it.
Thanks in Advance, Ray
BTW, they're asking $13,900 for it.
Thanks in Advance, Ray
#3
Is it a 4x4? I've got the same cab/engine configuration. Check the axle code, I've got 3.73's and would NOT want 3.55's. I do wish the truck had 4.10's though. I find the 4.6 to be adequate for driving around, towing and hauling small loads. I've seen alot of 2wd 4.6 screws with 3.55's, I never drove one, but can't imagine the 4.6 with 3.55's
#4
Run the VIN here https://www.fleet.ford.com/maintenan...ls/default.asp. It might give you a bit more info to use along with the Car Fax.
#5
Run the VIN here https://www.fleet.ford.com/maintenan...ls/default.asp. It might give you a bit more info to use along with the Car Fax.
I drive by the dealer everyday so on my why to work yesterday and before they opened, parked by truck and did a quick walk around. Overall looked pretty clean – one scratch on front bumper but had a look under the rear bumper and saw no trailer hitch which is one thing I would like to have. Are the newer F150s hitches “hidden” or if it has one, it should be in plan site?
Anyways, I think I'm just going to keep looking and glad I found this forum
#7
That's what I thought about the hitch. I did see what looked like the 7 pin plug though (see the attached pic). So dealer calls me this morning and I told him that I did stop by and noticed no hitch. He said they can put one in for ~$150 which sounds reasonable. Then I asked him to find out the rear ratio - I would want 3.73 min - 4.10 - he said he'd find out for me.
What am I looking for? 2004 (late model because they had the newer style) to 2007, SCrew, 4.6L, 'short' bed. If it's the right truck, up to $17K. Thanks for looking for me.
One other thing, they've lowered the price another $1,000 - $12,888 to be exact.
#8
Run the VIN here https://www.fleet.ford.com/maintenan...ls/default.asp. It might give you a bit more info to use along with the Car Fax.
#9