The ECU on my 95 is toast, and an OEM replacement ECU is going to be a ticking time bomb, and I'm not interested in getting a megasquirt set up, so I nabbed a junkyard intake from a 302 and a 4BBL carb. The issue I am facing is that I can't find the bit so I can get at the screws holding down the upper plenum, the one under the overhang on the plenum. I figure I need a long enough torx bit to get at it between the runners but I can't find any bits long enough, most come up a bit short.

Anyone know where I can get a long enough bit? The ones I found locally and on Amazon do not measure up.